26 of 28
IP-LOGIC AV over IP Technical Manual
TM-003-0001-100-00 | July 15, 2019
© 2019 Zigen Corporation
www.zigencorp.com
o
Do not loop back the 1Gbps interface to the same switch network as the 10Gbps
interface.
o
Do not use as a bridge between a 10Gbps switch to a 1Gbps switch.
•
Using this port allows 3
rd
party hosts (Audio Codecs, Computers, etc.) to participate in the
10Gbps AVoIP network.
USB Interface
IP-Logic extends USB 2.0 interface over IP. A USB Host such as a PC is typically connected to the
IP-Logic TX and a USB Device (Keyboard, Mouse, Webcam, Flash Drives) are connected to the IP-
Logic Rx. The RX is equipped with a two-port hub to allow multiple devices to connect to a host.
A virtual USB hub could be configured by connecting one Transmitter with up to seven Receivers.
It is important to remember that only one high-speed USB device (Webcams or Flash Drives) be
connected to an RX unit at any time. There are no limits to the number simultaneous
connections of low speed devices such as Keyboards and Mice.
IP-Logic Default Factory Settings
The IP-Logic devices are configured to factory defaults at the time of shipment. The following
are the default IPv4 Network settings:
IP Address
Subnet Mask
Gateway
ZIP-IPPRO-TX
DHCP (auto IP)
DHCP (auto IP)
DHCP
ZIP-IPPRO-TX
DHCP (auto IP)
DHCP (auto IP)
DHCP
Essentials AVoIP
DHCP (auto IP)
DHCP (auto IP)
DHCP
Essentials Control
DHCP (auto IP)
DHCP (auto IP)
DHCP
“
Zignet-Finder.
exe”
is a utility application to find connected IP Logic devices regardless of its
subnet location within the facility. Download the utility at the zigencorp.com website. Zignet-
Finder
can identify the device’s network information such as IP Address, Subnet Mask, and
Gateway. The utility can also change the device network information. The Essentials web-based
GUI can be found using a computer and a web browser (ie: Chrome, Firefox, Safari) and entering
Esssential’s hostname “ipessentials.local” or its IP Address on the brower’s url field.
Appendix