4. TouchLink
to
a
Zigbee
Lighting
Device
LED indicator
5. Removed from a Zigbee Network through Coordinator or Hub Interface
7. Remove a Touchlink Paired ZigBee Lighting Device
Note: 1) After pairing successfully, the remote information will appear on the controller or hub interface.
2) No remote information will appear on the hub interface if pairing to Philips Hue Bridge.
Step 1
: Set the zigbee lighting
device to start TouchLink
commissioning,
please refer to its
manual to learn how
.
ZigBee Lighting Device
< 10cm
Step 2
: Bring the remote within
10cm of the lighting device
.
Step 3
: Press and hold down until
LED indicator turns on.
Step 4
: Immediately short press to
st
art Touch
L
ink
c
ommissioning of
the remote
.
LED indicator flashes
fast for 3S, then flash 6 times slowly
to indicate successful pairing to the
device and the light connected to
the device will blink twice.
LED indicator
Step 1
: Set the Touchlink paired
zigbee device to start TouchLink
commissioning, please refer to its
manual to learn how
.
ZigBee Lighting Device
< 10cm
Step 2
: Bring the remote within
10cm of the lighting device
.
Step 3
: Press and hold down until
LED indicator turns on.
Step 4
: Immediately short press
twice to start TouchLink removing of
the remote
.
LED indicator flashes
fast for 3S, then flash 6 times slowly
to indicate successful removing.
Note: 1) Directly TouchLink (both not added to a ZigBee network), each remote can link with 30 devices.
2) TouchLink after both added to a ZigBee network, each remote can link with max. 30 devices.
3) For Hue Bridge & Amazon Echo Plus, add remote and device to network first then TouchLink.
4) After TouchLink, the remote can control the linked lighting devices.
Step 4:
Immediately short press to
search nearby network, indicator
flashes every 1 second, 20 seconds
timeout if there is no network.
Indicator will then blink 5 times
quickly for successful pairing.
Operation
1.This ZigBee RGBW remote is a wireless transmitter that communicates with a variety of ZigBee
compatible systems. This transmitter sends wireless radio signals that are used to remotely control a
compatible system.
2.This ZigBee remote supports 1 group for binding max. 30 lighting devices and enables to control RGB
ZigBee lighting devices.
3. Zigbee Network Pairing through Coordinator or Hub
(
Added
to
a
Zigbee
Network
)
Step 1:
Remove the remote from
previous zigbee network if it has
already been added to it, otherwise
pairing will fail. Please refer to the
part "Factory Reset Manually".
Step 2:
From your zigbee
controller or hub interface, choose
to add device or accessory and
enter Pairing mode as instructed
by the controller.
Step 3:
Press and hold down until
LED indicator turns on.
LED indicator
Step 2
: Immediately short press 5
times continuously, indicator
flashes 3 times quickly to indicate
successful reset.
6. Factory Reset Manually
Note: All configuration
parameters will be reset after the
remote is reset or removed from
the network.
LED indicator
Step 1
: Press and hold down until
LED indicator turns on.
From your ZigBee controller or hub
interface, choose to delete or reset
the remote as instructed, indicator
flashes 3 times quickly to indicate
successful removing.
