2X4 SPACER
FACING DOWN
2X4 SPACER
FACING UP
ROOF HOLE
3/8" X 6.50"
HEX HEAD BOLT
3/8" FLAT WASHER
Components required for Step 1:
(1)Middle Large Vertical Double Message Center
(2)Inground Post Assembly
Hardware required for Step 1:
(6) 3/8" x 6.50" Hex Head Bolt
(6) 3/8" Flat Washer
Step 1:
Lay out the required components as shown in the illustration. Attach the Inground
Post Assemblies to the Middle Large Vertical Double Message Center as shown.
Be sure to properly orientate posts as indicated. Place posts into post holes,
leveling where necessary. Fill post holes with filler.
Before Step 1 can be completed, two holes must be dug 41"
apart on center at a depth of 30" - 36". Make each hole
approximately 10" wide in diameter. These holes will be used to
construct middle section of the Zig Zag Message Center. Refer
to post hole layout at end of instructions for more detail.
