―
Not-skid footwear is recommended.
―
Wear restrictive hair covering to contain long hair.
―
Use eye and ear protection. Always wear:
ANSI approved dust mask or respirator when working around metal wood ,and chemical dusts and
mists.
A full face shield if you are producing metal or wood filings.
Ear protectors
―
Maintain proper footing and balance at all times.
―
Do not reach over or across running machines.
3.3 BEFORE OPERATING
―
Know the machine. Learn its applications and limitations as well as the specific potential hazards.
―
Check for damage. If part of the machine is damaged. It should be carefully inspected to ensure
that it can perform its intended function correctly. If in double the part should be replaced.
―
Be sure the switch is OFF before plugging in.
―
Make sure tool has been cleaned and properly lubricated.
―
Check for damaged parts before using any tool, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function.
―
Check for alignment and binding of all moving parts broken parts or mounting fixtures and any
other condition that may affect proper operation. Any part that id damaged should be properly
repaired replaced by a qualified technician.
―
Do not use the tool if any switch does not turn off and on properly.
3.4 SPECIAL SAFETY RULES FOR BAND SAWS
―
Adjusting the upper guide of saw blade to make it higher about 1/8" than the cut material.
―
Saw after the machine rolling regularly select different speed of filling material according to the
different hardness and thickness of wood. Forbid filling material too fast.
―
Check for proper blade size and type make sure that blade's tension and tacking are properly
adjusted according to the instruction to change saw blade.
―
The worker shouldn't leave the place when the machine is working. Don't forget to cut off the main
power source when not working.
―
Use foot bolt to forbid the machine learning to the ground.
4.
4.
4.
4. GROUNDING/VOLTAGE
GROUNDING/VOLTAGE
GROUNDING/VOLTAGE
GROUNDING/VOLTAGE
4.1 INSTRUCTION OF GROUNDING
―
This machine provided power outlet and cable. And there is grounding wire on it. The contact of
outlet on the sawing machine must connect with the case
of sawing machine. The other outlet should be correctly plug in the standard outlet should be
installed correctly and connected with the earth.
―
If grounding wire can't be connected properly, it may be struck, Change or repair cable or outlet
don't connect the grounding line wrongly.
―
When the cable is damaged, change or repair it in time.
4.2 CONNECTIONS OF POWER SOURCE
The single electric current should be used. The protector should be set in order to protect. Assure
that the line voltage should agree with the motor voltage on it's plate before running machine.
4.3 WIRE DIAGRAMS (MJ343B, MJ343C)
Содержание BS14
Страница 10: ......
