(SRE240E) The heater has been in operation
(SRE246E) continuously for a period of 69/50 hours hours
and has turned itself off automatically.
Switch the heater back on.
-- : --
+
Out of fuel.
Refill removable tank.
-- : --
+
Too little ventilation.
Ventilate better.
e - 1 1
+
Too little ventilation.
Ventilate better.
Always contact your Zibro dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 69 hours (SRE240E) / 50 hours (SRE246E) continuous operation.
The following will then appear in the display:
/
. If desired, you can
switch the heater on again by pressing the
button
M
(see Section D).
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaning code
cl:05
running back to
cl:01
. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
THE USE OF THE MOTION DETECTION SENSOR
This heater is equipped with a motion detection sensor. The sensor is placed at the
front side of the heater and it signals every single movement. The motion
detection sensor has a horizontal detection angle of 80
o
and a vertical detection
angle of 20
o
. The sensor detects movements as far as 7 m.
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. As a result less fuel will be used.
Switch on the motion detection sensor;
Switching on the motion detection sensor can only be done when the heater is
turned on. Push the “Motion” button
. A signal will sound and the “Motion”
light will light up (green).
If the sensor does not detect movements for 10 minutes then the heater will
automatically switch to a lower combustion level. The motion detection sensor
light keeps lighted up. If the sensor detects movement the motion light will blink.
The heater switches back to the latest temperature setting.
Switch off the motion detection sensor;
The Motion detection sensor can be switched off by pressing the “Motion” button
again. A sound signal will be heard and the “Motion” light will go out.
I
CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key
N
and holding it
down for more than 3 seconds. The KEY-LOCK indicator (
) will appear on the
information display (Fig. I), indicating that the childproof lock has been activated.
Switch off the childproof lock by pressing the key
N
and holding it down for more
than 3 seconds once again.
4
56
I: When the
mark
appears, the childproof
lock has been activated.