MANUAL
A
INSTALLING THE HEATER
Carefully remove your Zibro from the box and check the contents.
In addition to the heater you also need to have:
E
a manual fuel pump
E
a transportation cap
E
these directions for use
Keep the box and the packaging materials (Fig. A) for storage and/or transportation.
Open the lid of the removable tank
4
and remove the piece of cardboard.
Fill the removable tank as indicated in Section B.
The floor should be firm and completely level. Reposition the heater, when it
is not level. Do not try to correct the situation by placing books or other
goods under the heater.
Insert the plug
L
into the wall-socket (230 Volts - AC / 50 Hz) and set the
correct time using the adjustment keys
P
(refer to Section C).
Your Zibro is now ready for use.
B
FILLING FUEL
Do not fill the removable tank in the living room, but in a more suitable place
(there can always be some spillage). Follow the procedure below:
Make sure that the heater is switched off.
Open the lid
4
and lift the removable tank
7
out of the heater (Fig. B).
Note: Some drops may leak from the tank. Put down the removable tank
(cap pointing upwards) and screw off the fuel cap (fig. C).
Take the manual fuel pump and insert the smooth, most rigid tube into the
jerrycan. Make sure that it is in a higher position than the removable tank
(Fig. D). Insert the ribbed hose into the opening of the removable tank.
Lock the switch button on top of the pump (turn clockwise).
Squeeze the pump a few times, until fuel starts flowing into the removable
tank. As soon as this happens, there is no need to press any longer.
Check the removable tank fuel gauge
H
while filling the tank (Fig. E). Stop
filling by loosening the switch button on top of the pump (turn anti-clock-
wise), once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
6
5
4
3
2
1
6
5
4
3
2
1
4
45
E
E
E
E
E
E
D
E
empty
full
B
C
