f - 1
Faulty burner thermistor.
Contact your dealer.
e - 2
Starting problems.
Contact your dealer.
e - 5
Tipping-over protection.
Re-ignite the heater.
e - 6
Poor burning.
Contact your dealer.
e - 7
Room temperature
If necessary,
above 32°C.
re-ignite the heater.
e - 8
Defective booster.
Contact your dealer.
e - 9
Air filter dirty; or
Clean filter.
Fuel pump dirty.
Contact your dealer.
The heater has been in operation
continuously for a period of 48 hours
and has turned itself off automatically.
Switch the heater back on.
-- : --
+
Out of fuel.
Refill removable tank.
-- : --
+
Too little ventilation.
Ventilate better.
Always contact your dealer for any malfunctioning not listed above.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it switches off
automatically after 48 hours continuous operation. The following will then appear
in the display:
. If desired, you can switch the heater on again by pressing
the button
N
(see section D).
AUTOMATIC CLEANING MODE
When the heater has been burning continuously for two hours at its highest
setting, the burner will automatically start an autoclean procedure. The display
will show the autocleaningcode
cl:05
running back to
cl:01
. The procedure takes 5
minutes, during which the heater will burn at its lowest setting, while the burner
autocleans. When the burner is clean again, the heater will automatically switch
back to the highest setting again.
I
CHILDPROOF LOCK
The childproof lock can be used to prevent children accidentally changing the
heater settings. When the heater is burning and the childproof lock is on, the heater
can only be switched off. Other functions are blocked then. If the heater has already
been switched off, the childproof lock also prevents accidental ignition of the
heater. Activate the childproof lock by pressing the appropriate key
O
and holding it
down for more than 3 seconds. The KEY-LOCK indicator (
) will appear on the
information display (Fig. H), indicating that the childproof lock has been activated.
Switch off the childproof lock by pressing the key
O
and holding it down for more
than 3 seconds once again.
J
THE CORRECT USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
R
key.
will display on the
information display (Fig. I). Switch off the function by pressing the SAVE key once
again.
4
48
H: When the
mark
appears, the childproof
lock has been activated.
I: When the SAVE
function is activated, the
heater will automatically
switch on or off in order
to remain within a
specified temperature
range.
