Zibro R 24 C, Руководство по эксплуатации

Страница: 7 / 16

☞
After having ignited the heater, always check whether the combustion
chamber is level, by sliding it slightly to the left and the right by its handle
(Fig. F). This should be a smooth movement. If the combustion chamber is not
level, this will cause smoke and soot to develop.
D
BURNING OF THE HEATER
After you have ignited the heater, it will take 10 to 15 minutes before you can check
whether the heater is burning well. A too high flame may cause smoke and soot,
whereas a too low flame causes smells. The page opposite the folding page shows
the minimum and maximum permissible burning heights of the flame (Fig. Q). The
flame can be slightly adjusted with the knurled wick adjustment knob (Fig. M).
Burning that is too low may be caused by:
insufficient fuel (fill the tank)
poor fuel quality (contact your dealer)
insufficient ventilation (put window or door ajar)
wastage of the wick (contact your dealer or replace the wick,
refer to section L)
When there is insufficient ventilation in the room, the heater shuts off automati-
cally. After improving the ventilation of the room (e.g. by opening a door or win-
dow a little more), the heater can be ignited again.
This heater is equipped with a safety mechanism which switches off the heater when
the removable fuel tank is taken out of its compartment. To re-ignite the heater, place
the removable fuel tank back in the heater and follow the instructions as described in
chapter C.
E
SWITCHING OFF THE HEATER
Push the OFF-button . The flame will extinguish after a little while (Fig. N).
F
MALFUNCTION, CAUSES AND SOLUTIONS
If any malfunctioning cannot be solved from the directions below, please contact
your dealer.
THE HEATER DOES NOT IGNITE
The batteries are not positioned correctly in the holder.
Check (Fig. G).
There is not enough power left in the batteries for the ignition.
Replace (Fig. G).
You have run out of fuel from the tank or the wick has been replaced.
After having refilled and replaced the removable tank, wait for 30 minutes
before igniting the heater.
You are pushing the ignition button with too much force.
Push it in less forcefully (Section C).
The ignition coil is defective.
Contact your dealer.
4
55
☞
M
N
G
F