The wires must be connected as described above method, or it may cause damage to the
tester.
Note: EPM5800-E is not a shell. There is a high voltage when powered, prohibiting any part
of the body contacting the circuit board.
button
Power factor/switching frequency
Press the left button "YF/TEAM (INK)" when working steadily to switch to show power
factor or frequency.
Matters needing attention
1. The tester cannot work in hot and humid conditions, please use it under normal conditions;
2. From the back of the meter, the left terminal 3,4 connect the input of the power supply,
the right terminals 1,2 connect the output of the power supply, do not connect the reverse
side.
3. The test voltage cannot exceed AC265V, DC voltage cannot exceed DC300V;
4. If the working current is greater than 10A or the load shorted can damage the fuse, then
you need to replace a new 10A fuse.
5. Do not expose the tester to dusty, corrosive gases and other harmful substances in the
environment when storing and using;
6. Do not touch any part except the panel when the tester is working, the tester with high
voltage may cause electric shock.
Problems often
1. The tester does not work with the power supply, please check the power cord connection.
2. Test display "o", which may be damaged fuse, please replace a new fuse.
Hole size (unit mm):
