SkyZhone 1600, 1400, 1200 Hardware Installation Guide
37
Initial Configuration
Using the factory defaults
•
The factory defaults for the SkyZhone Access Point includes two VLANS.
•
VLAN 1
is the default data VLAN.
Ports
eth1
(PoE), and
wlan0
are all members of this VLAN.
•
VLAN 7
is the default management VLAN.
Ports
eth1
(PoE) are members of this VLAN.
Before using the SkyZhone Access point, use the CLI commands on the console
interface to assign an IP address to the SkyZhone access point. For your network,
determine the appropriate IP addresses as well as subnet mask, default gateway and
broadcast address settings. The SkyZhone access point can now be configured for
management.
In the following example, the values for the settings for the network are:
•
IP address: 10.108.14.218
•
Subnet mask: 255.255.255.0
•
Broadcast Address: 10.108.14.255
•
Default gateway: 10.108.14.254
Use the following three commands to configure VLAN management.
•
config if interface brvlan7 ip 10.108.14.218 mask 255.255.255.0
broadcast 10.108.14.255
•
config if route-add destination default gateway 10.108.14.254
•
config admin-tools save running-config
After entering these commands, the system can be managed using SSH or HTTPS
over the PoE interface.
Refer to the
SkyZhone CLI Reference Guide
for a list of supported commands to
configure advanced SkyZhone features.
Changing the factory defaults
If you are not using the factory default VLANs, you need to delete the default
VLANs and configure the VLANs that are appropriate for your network. In the
example below, VLAN 2 is used for management instead of the default VLAN 7.
Also, VLAN 122 is the data VLAN instead of VLAN 1.
