Zhone EtherXtend 3300 Series, Руководство пользователя

Страница: 115 / 150

EtherXtend bridge commands
EtherXtend User’s Guide
113
Creating TLS bridges on the EtherXtend CPE 2
When using TLS bridges on a device, both the WAN port and the LAN port
must use TLS bridges.
1
To find the bond group number on the WAN, enter the bond show all :
zSH> bond show all
Bond Groups
Slot GrpId Name Type State
1 40 1-1-40-0 efmbond ACT
2 To create a TLS bridge interface on the WAN port using the bond group
number, enter
bridge add interface/type tls :
zSH> bridge add 1-1-40-0-efmbond-0/bridge tls
3 To create a TLS bridge interface on the LAN port to the business, enter
bridge add interface/type tls :
zSH> bridge add 1-1-1-0-eth/bridge tls
4 To verify the bridges created, enter bridge show:
fm1> bridge show
Typ VLAN Bridge St Table Data
---------------------------------------------------------------------------------
tls 0 1-1-1-0-eth/bridge UP
tls 0 1-1-40-0-efmbond/bridge UP
EtherXtend bridge commands
The EtherXtend supports the following bridge commands:
•
Bridge delete command on page 113
•
Bridge show command on page 113
•
Bridge stats on page 114
Refer to the Zhone CLI Reference Guide for a detailed explanation of the
available bridge commands.
Bridge delete command
The bridge delete command deletes a specific bridge entry from the system.
zSH> bridge delete 1-1-40-0-efmbond-0/bridge
1-1-40-0-efmbond-0/bridge Delete complete
Bridge show command
The bridge show command displays either a single bridge path entry or the
entire bridge table.