4.4 PREASSEMBLY OF HOUSING
4.4.1 Assembly of outer races
(tapered roller bearings)
Heat "output" half of the housing (item 1, Fig. 4-1) in an
oven to approx. 120ëC (248ëF).
Insert outer races (item 2, Fig. 4-1) into housing.
|
WARNING
|
Handle heated tapered roller bearings outer races
on with protective gloves.
When housing has cooled down to ambient tempera-
ture, with a press seat outer races carefully into hous-
ing.
4.4.2 Installation of fluid suction pipe
.
Position oilsuction pipe (item 1, fig. 4-2a) in the
housing.
.
Put one drop of Loctite 243 into screw threaded
hole.
.
Lightly tighten the screw (item 2, fig. 4-2a).
.
Insert centre square punch and tighten definitely
the screw.
.
Adjust oilsuction pipe to measure "
A
" (A=26 mm)
(Fig. 4-2b)
.
Put some ATF fluid on the seal seat and on the oil
suction pipe using a brush.
.
Press into housing over the oilsuction pipe the seal
(item 2, fig. 4-2c) using the appropriate punch
(Fig. 4-2c).
21
Repair Manualand Spare Parts List
Section 4
2
120
˚C
248
˚F
2
1
FIG. 4 - 1
1
2
FIG. 4 - 2a
1
A
FIG. 4 - 2b
2
1
A
FIG. 4 - 2c
