ZF ZF 45 IV, Руководство по эксплуатации

Страница: 21 / 26

MAINTENANCE
21 EN 3201.758.001a 2016-02
4.3 ADJUSTING SHIFT CONTROL LINKAGE
With the engine off, unplug the shift control linkage connecting cable with the control valve lever.
Put the lever in the forward drive position. Select the same direction with the bridge console control lever and check
that the positions of the respective couplers (lever/cable) coincide.
Repeat the operation for the opposite direction and, if any irregularities are found, adjust the linkage accordingly. Now
check that the neutral position of the lever at the console coincides with the neutral position of the controlvalve lever.
Repeat the operation on the "Flying Bridge", if present. This operation must also be repeated after the first few hours
of running.
4.4 CHECKING FLEXIBLE COUPLINGS
Replace the flexible coupling if, on close inspection, the rubber part has tears or is contaminated with lubricating oil.
Remove the ignition key before cranking the engine.
Do not use chemicals on rubber components. Check that all threaded parts