ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 38 / 160

SET-UP PROCEDURES
Page 30
• When in Set-up Mode, the LED’s display two digit values Refer to
Figure 30:
6.2 A
CTIVATING
S
ET
-
UP
M
ODE
A)The Display is in Normal Operating condition with red running
center dash lines.
B)Depressing either the Up or Down Arrow Push Button will acti-
vate the Function Menu. (refer to Figure 32:)
C)Depressing either the Up or Down Arrow Push Button will scroll
through the Function Menu one at a time.
D)Once the desired Function Code is visible on the Display,
depressing and holding the Left and Right Arrow Push Buttons at
the same time will activate Set-up. The left two Display pads will
begin to blink, indicating that the value is ready to be changed.
Refer to Figure 33:
Figure 30: Display with Value more than Two Digits
NOTE: To escape from the set-up procedure at any time without saving the changed value.
Depress the LEFT Arrow Push Button. The Function Code will stop flashing and the
Function will be saved with the original value.
Figure 31: Display Normal Operating Condition
Figure 32: Display Function Menu Activated
Blinking