ZF CruiseCommand 785CE, Инструкция по установке и устранению неисправностей

Страница: 137 / 160

Throttle Testing TRAIN-157 Rev.B 6/01
Page 40
H)The appropriate Full Throttle Duty Cycle for the application
should be measured as shown in Figure 34:. If the voltage is
slightly off, it may be adjusted using the Throttle Maximum "
E3 "
function.
I) Return the Control Head lever to the Neutral/ Idle position and
turn power ‘Off’ to the Processor.
J) Remove the Test Unit and plug the Throttle Harness back into the
Processor’s Throttle Socket.
2.4 PWM (P
ULSE
W
IDTH
M
ODULATION
)
WITH
DC V
OLTMETER
A)Ensure power is removed from both the Engine Electronics and
the CruiseCommand Processor.
B)Disconnect the Throttle Harness from the Throttle Socket on the
Processor.
C)Insert the Test Unit between the Throttle Socket and the Throttle
Harness as shown in Figure 35:.
Figure 34: Dwg 11653-F