ZF Marine ClearCommand, Руководство пользователя, Страница: 51 / 104

ADJUSTMENTS AND TESTS UNDERWAY
Page 45
E) Store the value that has been set by following Section 6.1.6, page 27
8.2.2 Speed Boost Timeout
This is the amount of time boost is applied. Parameters are 0 - 5 seconds.
The default value is 0 seconds. To change the Speed Boost Timeout per-
form the following steps:
E) Store the value that has been set by following Section 6.1.6, page 27
8.2.3 Speed Boost Start Timeout
This is the amount of time before boost starts. Parameters are 0 - 5 sec-
onds. The default value is 0 seconds. To change the Speed Boost Start
Timeout perform the following steps:
E) Store the value that has been set by following Section 6.1.6, page 27
Figure 31: Dip Switch Setting
Speed Boost Timeout
A) Place the System in Set-up Mode by following Section 6.1.5,
page 26.
B) Place the appropriate Dip Switches ON to activate Speed
Boost Timeout.
• Refer to Figure 31: for the Dip Switch settings.
C) Verify engines are running.
D) Rotate Potentiometer R7 clockwise while monitoring the
engine RPM. Adjust to the desired Speed Boost Timeout
RPM
CAUTION: Turning too hard against the stop can damage Potentiometers.
Figure 32: Dip Switch Setting
Speed Boost Start Timeout
A) Place the System in Set-up Mode by following Section 6.1.5,
page 26.
B) Place the appropriate Dip Switches ON to activate Speed
Boost Start Timeout.
• Refer to Figure 32: for the Dip Switch settings.
C) Verify engines are running.
D) Rotate Potentiometer R7 clockwise while monitoring the
engine RPM. Adjust to the desired Speed Boost Timeout
RPM
CAUTION: Turning too hard against the stop can damage Potentiometers.
0657-600
12
3
4
56
7
OFF
To change, use a
small screwdriver.
PUSH DOWN
FOR ‘ON’
PUSH DOWN
FOR ‘OFF’
OFF
OFF
OFF
ON
ON
OFF
ON
0657-600
12
3
4
56
7
OFF
To change, use a
small screwdriver.
PUSH DOWN
FOR ‘ON’
PUSH DOWN
FOR ‘OFF’
OFF
OFF
OFF
ON
ON
OFF
ON