ZF Marine ClearCommand 9000 Series, Инструкция по установке, эксплуатации и устранению неисправностей

Страница: 257 / 272

SERVICE FIELD TEST UNIT
MM13927 RvD 10/03 Page 2-5
C) Insert the Break-out Box between the number
1
Processor con-
nector/pigtail and the Throttle Harness as shown in Figure 2-
8:
D) Set up the Multimeter to measure Frequency and plug the
black lead into the Break-out Box black socket labeled “-“ and
the red lead into the socket labeled “FREQ”.
E) Turn power ‘On’ to the Processor and take command at any
Remote Station.
F) The appropriate Idle Frequency for the application should be
measured at this time.
G) Move the Control Head lever to the Full Throttle position
while depressing the Transfer Button (Throttle Only Mode).
H) The appropriate Full Throttle Frequency for the application
should be measured at this time.
Figure 2-8: Throttle Connection (Frequency Hz)