11
10
Pair-up the Blood Pressure Monitor
with Your Bluetooth Device
1
.Turn on Bluetooth and the Zewa app. Make sure both are ON when
pair-up is proceeding.
2
.When the monitor is OFF, press
start pair-up. The symbol
and the symbol will be
shown on the LCD alternatively,
indicating pair-up is proceeding.
If SUCCEED
, symbol
will be shown on the LCD.
If FAIL
, symbol will
be shown on the LCD.
3
.The monitor will shut off after Pair-up
process is complete.
Bluetooth Module No.:
AW8001
RF Frequency Range:
2402 MHz to 2480 MHz
Output Power Range:
0 dBm
Supply Voltage:
1.8-3.6 V
Transmitting Distance:
10 meters
and hold the button (User 2) to
Resting for 5 minutes before
measuring.
Wait at least 3 minutes between
measurements. This allows your
blood circulation to recover.
For a meaningful comparison,
try to measure under similar
conditions. For example, take daily
measurements at approximately
the same time, on the same arm,
or as directed by a physician.
Tie the Cuff
1
.Tie the cuff on your upper arm,
the position the tube off-center
toward the inner side of arm in
line with the little finger.
2
.The cuff should be sung but not
too tight. You should be able to
insert one finger between the
cuff and your arm.
3
.Sit comfortably with your left
arm resting on a flat surface.
2~3cm
MEASUREMENT
BEFORE YOU START
CAUTION
Interference may occur in the vicinity of equipment marked with the following symbol
. And UAM-910BT may interfering vicinity electrical equipment.
Sensitive people, including pregnant women pre-eclamptic and those who implanted
medical electronic instruments, should avoid using the unit whenever possible.
Keep the monitor at least 20 centimeters away from the human body (especially the
head) when the data transmission is proceeding after measurement.
To enable the data transmission function, this product should be paired to Bluetooth
end at 2.4 GHz.
How to mitigate possible interference?
1. The range between the device and BT end should be reasonably close, from 1
meter to 10 meters. Please ensure no obstacles between the device and BT end
so as to obtain quality connection and to lower the RF output range.
2. To avoid interference, other electronic devices (particularly those with wireless
transmission / Transmitter) should be kept at least 1 meter away from the monitor.
