3
After you did this press the ON/OFF Button to turn the XN-12 on/off. When
you turn the XN-12 on the XN-12 will be on spotlight mode and the light
brightness is 100%.
Press the ON/OFF button again after switching ON to switch to spotlight
mode 50% brightness.
Press the ON/OFF button again after switching mode to switch to red LED
triangle mode 100% brightness.
Press the ON/OFF button again will set the XN-12 on red LED triangle
strobe mode. When you press the ON/OFF again the XN-12 will be turned
off.
Fold out the stand on the back of the XN-12 to place it down, light angle
can be adjusted with the stand depending on the use.
When the XN-12 is almost empty the light will be dimmed to save energy,
for the spotlight mode this happens after 7 hours, after dimming the
spotlight will still last another 9 hours, total 16 hours.
For the red triangle LED mode 100% mode the runtime will be around 5
hours, then the light will dim and last another 5 hours. So the total runtime
is 10 hours red constant light. The red stroboscope mode works for
approximately 24 hours.
Charging ports can be found under the red rubber cover on the backside of
the XN-12.
The included Micro USB cable or any other Micro USB can be used for
recharging in combination with any 5v 1A USB wall or car adapter. A LED
indicator next to the micro USB port shows the charging status, red blinking
LED means still charging and a solid red LED means fully charged. A full
recharge will take around 6-8 hours. Simply plug the Micro USB side into
the triangle and the USB side into a 5v 1A wall/car adapter or other USB
device.
In case you cannot recharge the XN-12, the 18650 rechargeable lithium
batteries can also be replaced with 3 AAA batteries. Remove the 18650
