![background image](http://html1.mh-extra.com/html/zetron/4000-series/4000-series_installation-manual_3536674145.webp)
145
Harris M7300 Wireless Interface Option
Versions
This kit was tested with the following combination of software and firmware versions:
• Zetron Integrator RD 5.1 and newer
• Harris RPM (Radio Personality Manager): R05C03
• Harris M7300 boot app version: R12A00
• Harris M7300 burn app version: R09J02
• Harris M7300 ECP (main control firmware): R14A18
• Harris M7300 DSP firmware: 12.13 (note: part of the ECP)
• Harris M7300 CH-721 Control Head: R05A02
Recommendations
• Each of the radios should operate from its own 12VDC power supply.
• For each radio in the system to achieve proper performance and stability, it is
important that adequate separation be provided among all of the radio antennas for
the system.
Radio Setup
A Harris radio personality must be programmed to support the interface to a Zetron
IntegratorRD console.
To take advantage of the console ID alias capability, no LID information (or aliases)
should be programmed into the radio (no individual call IDs should be programmed). The
reason for this is that Integrator RD uses the radio's ID as a key to its alias database entries.
This will ensure that the number on the radio's display is the radio's ID. Once this radio ID
is obtained, RD will look through its alias database for a corresponding entry. If an alias is
found, it shall be used by the console for purposes of identifying the radio. If a matching
alias cannot be found, then RD shall simply display the original radio display text.
Radio Programming
Use the following procedure to program a radio for operation using Radio Personality
Manager (RPM). The following steps are based on a specific version of RPM and may
only be used approximately for other versions. The control head is required for
programming the radio.
To program the radio
1. Connect a programming cable between the rear of the radio and a serial port on the
programming PC.
2. On the PC, start up RPM. Power up the radio control head to get into programming
mode.
3. Read the contents of the radio. When prompted for the radio type, select:
M7300
.
Содержание 4000 Series
