ZETRON 025-9623 D3, Руководство пользователя

Страница: 15 / 55

Connecting the Components
15
Power Ports
A single power connection to the iRIM adapter, meeting the following specifications,
provides sufficient power for the iRIM, the iRIM adapter, and two i365 radios including
TX/RX operation and battery charging occurring simultaneously.
Table 2: iRIM “+13.5Vdc/GND” Input Pinout
Pin Description
1 10.5 Vdc to 16 Vdc, 3.2 amps
2 Ground
♦
To connect power
1. Connect cable 709-7966 from the iRIM adapter’s output port to the power port
on the iRIM as shown in
Figure 3
.
2. Using the screw terminal provided with the iRIM, connect power to the iRIM
iDEN i365 Adapter as described in
Table 2
and as shown in
Figure 3
.
Radio Ports
♦
To connect the iRIM to the iRIM adapter
1. Use cable 709-0065 (or a standard CAT5 Ethernet patch cable) to connect the
Radio A port on the iRIM to the iRIM Radio A port on the iRIM adapter, as
shown in Figure 3 .
2. Use cable 709-0065 (or a standard CAT5 Ethernet patch cable) to connect the
Radio B port on the iRIM to the iRIM Radio B port on the iRIM adapter, as
shown in Figure 3 .
♦ To connect an i365 radio to the iRIM adapter
1. Plug the 8-pin modular connector on the supplied cable (part number 709-7964)
into the appropriate RJ-45 jack on the back of the iRIM adapter (either Radio A
or Radio B ) as shown in Figure 3 .
2. Connect the other end of the cable to the radio.
3. Repeat for additional radios.
Network Port
The Network Port is initially connected to a computer by way of Ethernet during initial
configuration of the iRIM. A computer on the same network (or connected by a crossover
cable) uses a web browser to configure the iRIM. After initial configuration, the iRIM is
Network Port is connected to a COM port on the DCS-5020 Digital Switch or the Acom
Console Unit, by way of an Ethernet-to-Serial convertor.