Zetor PROXIMA HS Series, Руководство оператора

Страница: 146 / 212

Adjustment of toe-in of the wheels of the front driving axle
C507
Note: Tractors are in standard equipped with hydrostatic device.
z
Set the wheel symmetrically with longitudinal axis of a tractor.
z
Measure the distance between rims in the front on horizontal level of wheel axis. Mark the place of
measurement.
z
Travel forward with a tractor so that the marked places would be on horizontal level of rear wheel axis
(turn by 180°) and remeasure the distance between marked places.
z
Release locking nuts of ball joint heads (2) of connecting rods of devices in hydraulic cylinder.
z
Adjust toe-in by turning the pin of ball joint (3). Do the adjusting symmetrically with both joints to keep the
same lock of wheels to both sides (do the measurement on the sides of rims).
z
Locking nuts of heads of ball joints (2), tighten with a torque of 122 - 136 N. Upper surfaces of heads must
be (1) parallel.
Setting wheel stops with front drive axle
Set the stops always with any wheel track change or tire
replacement with front drive axle.
Wheel stops with front drive axle must be set so that there
would be a distance of at least 50 mm between front drive
axle tires and tractor with full lock and full axle swing
around central pin.
Setting wheel stops with front drive axle check
1. Set full lock to one side and check that the distance
between a tire and the nearest solid point on the tractor is
at least 50 mm. Check both front tires.
2. Turn the steering to full lock to the other side and check
according to point 1.
3. Heave one side of the front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
4. Hoist the other side of front axle to the maximum swing
(front axle leans against the bracket) and check according
to point 1 and 2.
The setting of stops (A) changes after the release of a nut
(2) and unscrewing or screwing in a screw (1).
After the change in setting wheel stops with
front drive axle, it is always necessary to check their
setting according to points 1 to 4.
E502
WHEEL TREAD CHANGE
145