Zetor CRYSTAL 150, Руководство оператора

Страница: 86 / 182

Stopping the tractor - manual brake
Stopping the engine
Leaving the tractor
Warning signalization of hydrostatic steering failure
Stop the tractor slowly under standard conditions. Shortly
before stopping:
1. Depress the clutch pedal.
2. Shift the main gear shifting lever to neutral position.
3. With every stopping, secure the tractor against
spontaneous dead start by manual brake.
C15N142
After the work of tractor when the engine was fully loaded,
it is necessary to secure its cooling.
1. Before stopping the engine, lower the revolutions to 800
- 1000 revolutions per minute and allow it to run for the
time of approximately 5 minutes.
2. Shift the lever of manual throttle to STOP position.
3. The engine stops after turning the key from 'I' position
to '0' position.
C15N143
Before leaving the tractor with a safety cabin, do not forget
to remove the key from the switch box in '0' position (in
position 'I' and 'II' the key cannot be pulled out).
Tractor must be secured against spontaneous start:
1. Engine off
2. Braked by manual brake
3. Wheels based by wedges.
Engaging a speed gear does not secure the
tractor from start (clutch is switched off).
Lock the cabin.
FH12N077
Hydrostatic steering pump failure is with oil pressure drop
under 120 kPa behind a pump signalized on a dashboard
by an applicable symbol.
Note: When starting the tractor or with low engine
revolutions, the control may blink, if it switches off after
starting or increasing the revolutions, it is not a failure.
C15N091
DRIVING OPERATION
85