2
MULTI RELAY OUTPUT MODULE INSTRUCTION MANUAL
General
The SCM-RM is a relay module that is designed to be DIN mounted inside of a Smart Connect Multi-loop control
panel. It’s powered and is interfaced to the panel via a RJ45 connection. The module has three form C relays which
can be typically used to control lift operation during an alarm, start fire pumps or stop ventilation fans etc. Each relay
output can be configured as a common alarm, common fault, common technical alarm or a programmable output
via the Smart Connect Multi-loop settings.
Installation
1.
Ensure that the installation area is free from any cables or wires that may get caught, and that there is enough
space on the DIN rail to mount the module. Also ensure that the DIN clip underneath the module is in the open
position.
2.
Place the module onto the DIN rail, hooking the metal earth clip underneath onto the rail first.
3.
Once the earth clip is hooked, push the bottom of the module onto the rail so that the module sits flat.
4.
Push the plastic DIN clip (located at the bottom of the module) upwards to lock and secure the module into
position.
5.
Once the module is secured to the DIN rail, simply connect the supplied CAT5E cable to the module’s RJ45 port.
6.
Connect the other end of CAT5E cable to the nearest unoccupied RJ45 port on the termination PCB.
ATTENTION:
THE PANEL MUST BE POWERED DOWN AND DISCONNECTED FROM THE BATTERIES BEFORE
INSTALLING OR REMOVING ANY MODULES.
