Zero UAV (Beijing) Intelligent Technology Co., Ltd. 12
3.1.8
Wiring diagram
Electronic Speed
Controllers(M1-M4)
LED Indicator Light
S-BUS receiver
extension
port
6S battery
WiFi module
com3
+
Power
-
Parachute
steering engine
white
brown, black
red
Aviation plug switch line
Gimbal and
frame can be
divided here
Main Controller Circuit Board
·
The Controller Circuit Board is mounted in
the centre of the Aircraft Centre Plate by
pasting("front" arrow point to forward of
aircraft).
·
It should be ensured that all of flight
controller terminals are uncovered so as to
facilitating wiring and firmware upgrading.
·
After finalizing the position of flight
controller,it's advised that completing the
wiring and software setting before fixing
them in position.
Receiver
·
Set up channels of
aileron,elevator,throttle and rudder on
the remote controller.
·
The receiver(support S-BUS) get the
power from flight controller directly
instead of External Power Source.
·
S-BUS converter should be chossen from
manufacturer if there isn't S-BUS
receiver.
LED Indicator Light
LED Indicator Light
should be installed in a
convenient
position,away from
GPS,ensuring it could be
seen during flighting.
extension
port
GPS Module
·
GPS and Magnetic Compass
module should be kept away from
other electronic equipments
because it's Magnetically Sensitive
Equipments.It also should be
installed by the original GPS frame.
·
For it's sensitive to shaking,GPS
should be installed firmly.Logo side
should be upward and small arrow
should face forward,without
extending GPS line.
·
Flight controllers could only work
after GPS installation.
5.7V
EXT2
EXT1
Gimbal
CLOCK
DATA
AV/vedio Power
supply to
Gimbal
S-BUS receiver
white
red
Brown, black
5.7V
Connect to the vedio input line
of GIMBAL(brown, white)
Parachute
signal
Internal power
supply system
left landing gear
right landing gear
Figure 11 Wiring diagram
