Zero Motorcycles 2014 ZERO S, Руководство пользователя

Страница: 66 / 128

General Operation
4.16
Compression Damping
The compression damping is adjusted by turning a screw
on the bottom of each fork leg. There is a rubber dust
cover protecting the jam nut (A) securing the screw (B).
The adjuster has 12 stages of adjustment.

Turn the adjuster clockwise for slower compression.

To speed up compression, turn the adjuster
counter-clockwise.
Start with a middle setting and fine tune the compression
from there. Proper compression allows the tire to track the
ground over consecutive bumps. Compression that is set
too slow will pack-up (feel harsh over consecutive bumps)
while compression that is set too fast will cause the fork to
bottom out harshly. If the fork is bottoming out, turn the
adjuster one click at a time until the bottom-out stops.
Adjust each fork leg evenly. Replace the rubber dust cover
after the adjustment.
Note: Adjusters should never be forced completely “Fast”
or “Slow”; always leave one click of adjustment in either
direction.
Factory Supplied Front Suspension Settings
The following information will allow you to adjust the front
suspension back to the factory settings the motorcycle was
originally supplied with.
S & SR Models
ADJUSTMENT SETTING
Front Fork Compression 10 clicks out from fully closed
Front Fork Rebound 10 clicks out from fully closed
DS Models
ADJUSTMENT SETTING
Front Fork Compression 9 clicks out from fully closed
Front Fork Rebound 10 clicks out from fully closed