EDA-R6000 Installation Manual
Page
3
of 6 Ref: EDA_R6000_install_V107.doc
Electro-Detectors
Sounder Tone List
Two tones are available. A swept tone that should be used as a general evacuate tone and a single frequency tone that is
pulsed and used for an alert signal.
To achieve EN54 Part 3 compliance the swept tone must be used with the maximum (High) volume setting.
When programming the panel, for each device that can set the system into alarm, a set of cause and effects can be
programmed to determine how the sounders operate. The options are detailed below. The system defaults to sounder
tone number 0 and has been type approved to this. Other options have not been approved. Four user defined tones can
be added to the system.
The swept tone sweeps from 1056Hz to 918Hz in 500mS
The pulsed single frequency operates on a 50% duty cycle and is on for 1 second.
Sounder
Tone
Number
Tone Name
Tone Description
0
Swept
Swept Tone
1
Pulsed
Pulsed 1s on 1s off
2
Swept
Swept Tone
3
Pulsed
Pulsed 1s on 1s off
4
Swept
Swept Tone
5
Pulsed
Pulsed 1s on 1s off
6
Swept
Swept Tone
7
Pulsed
Pulsed 1s on 1s off
8
No Tone
No Tone
9
No Tone
No Tone
10
No Tone
No Tone
11
No Tone
No Tone
12
User Tone A
User Tone A
13
User Tone B
User Tone B
14
User Tone C
User Tone C
15
User Tone D
User Tone D
