EN
24
TROUBLE
CAUSE
SOLUTION
After connecting the machine to the power outlet
the LED for low water level starts flashing and an
acoustic signal is heard.
The water level in the tank is low.
Unplug the machine.
Fill up the water tank and plug it in again.
The steam ready LED is on but no steam comes out.
The hose is not completely connected.
Check the hose is correctly fitted to the
appliance.
The steam regulator is completely closed.
Open the steam regulator.
While working, an accessory detaches itself.
The accessory is not correctly connected.
Check that the accessory is correctly connected.
Vacuum power is too low or performance goes
down while working with the vacuum.
A filter is dirty blocking intake.
Check and clean filter.
The filters are not properly mounted.
Check filter and if necessary reposition.
Air is coming in where it should not.
Check that the cover, hose and accessories are
correctly mounted and fastened.
The seal along the water bucket is not properly
positioned.
Reposition correctly the seal between the bucket
and cover.
The hose or an accessory is obstructed by dirt.
Check and free the passageway.
The pivoting front wheel passage is obstructed.
Check and free the passageway.
The motor works correctly but vacuum
performance is poor.
The floater is closing the air passage.
Empty the water bucket and fill up to minimum
level with clean water.
The hose or accessories smell unpleasant.
Dirt and grime has accumulated in the hose,
accessories or bucket.
Clean all parts with clean water and if necessary
light detergent, but make sure to clean and dry
after each use.
12 - TROUBLESHOOTING
