Zephyr VALINA ZVA-M60AS290, Руководство по установке

Страница: 6 / 60

Safety instructions 3/4
A.
Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated con-
struction.
B.
Sufficient air is needed for proper combustion and exhausting of gases through
the flue (chimney) of fuel burning equipment to prevent back drafting. Follow
the heating equipment manufacturer’s guideline and safety standards such as
those published by the National Fire Protection Association (NFPA), and the
American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
C.
When cutting or drilling into wall or ceiling, do not damage electrical wir-
ing and other hidden utilities.
D.
Ducted fans must always be vented to the outdoors.
E.
This unit must be grounded.
WARNING
- TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.
WARNING
- UNDER CERTAIN CIRCUMSTANCES DOMESTIC APPLIANCES MAY
BE DANGEROUS.
A.
Do not check filters with hood working.
B.
Do not touch the lamps after a prolonged use of the appliance.
C.
No food must be cooked flambè underneath the hood.
D.
The use of an unprotected flame is dangerous for the filters and could cause
fires.
E.
Watch constantly the fried food in order to avoid the cooking oil flares up.
F.
Before performing any mainteinance operation, disconnect the hood from
the electrical service.
The manufacturers will not to accept any responsibility for eventual damages,
because of failure to observe the above instructions.
Electrical Requirements
Important:
- Observe all governing codes and ordinances.
- It is the customer’s responsibility to be aware of these below:
- To contact a qualified electrical installer.
- To assure that the electrical installation is adequate and in conformance with
National Electrical Code, ANSI/NFPA 70 latest edition* or CSA standards C22.1-
94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and
all local codes and ordinances.
- If codes permit and a separate ground wire is used, it is recommended that a
qualified electrician determine that the ground path is adequate.
- 6 -