TROUBLE SHOOTING
SPRAYER WILL NOT SPRAY AT ALL
A) Sprayer is completely full of liquid. Only fill sprayer
2/3 full (24 ounces).
B) No air pressure. Pressurize.
C) Nozzle is clogged. Clean or replace nozzle.
PIN STREAM ONLY
A) Liquid too thick. Thin until sprayable. Consult your
liquid supplier for correct thinning procedures.
B) Too little air pressure. Minimum of 80 psi.
LEAKS FROM P115 STUFFING BOX NUT
A) P115 stuffing box nut is loose. Tighten P115 1/16th
of a turn and apply a drop or two of lubricant to
the T29701 valve stem at the rear of the P115. Tilt
the sprayer so that the lubricant runs into and
around the P115. Depress trigger a few times to
work in the oil.
STUCK OR DRAGGING TRIGGER ACTION
A) P115 stuffing box nut is too tight. Loosen P115 nut
1/16th of a turn and apply a drop or two of lubricant
to the T29701 valve stem at the rear of the P115. Tilt
the sprayer so that the lubricant runs into and
around the P115. Depress trigger to work in oil.
Retighten slightly for proper action.
AIR FILLER ASSEMBLY WON’T ACCEPT AIR
A) Air filler assembly has been damaged. Replace.
LEAKS FROM NOZZLE
A) Dirty or worn face on T29701 valve. (See Cleaning the
T29701 valve on previous page)
B) P115 stuffing box nut is too tight. (See stuck or
dragging trigger action on this page)
LEAKS BETWEEN BODY AND CANISTER
A) O’Ring is dirty. Clean and wet.
B) O’Ring is damaged or worn. Replace.
TROUBLE SHOOTING
(5)
