15
Assembly
Please check that the pruning shears, wires and batteries are clean and dry, and then follow the
steps below to assemble:
1) Place the battery pack in the battery compartment, securing the battery after you hear a
click. Make sure that the connector is facing right if you are right-handed Check the
opening and closing position of the pruning shears
2) Grip the handle with your hands
3) Turn on the power switch, pull two scissors to the trigger in a row and open the scissor
head. You can start the operation.
Operating Instructions
When using this device, wear suitable clothing and work gloves. The risk of injury can be
reduced by wearing a protective device and ensuring that the device is functioning
properly.
Make sure the device is functioning properly before each use. The start/off switch and
safety switch must be in working use. If the switch is loose, the power must be turned
off. If the switch is damaged, stop using the device.
Ensure that the voltage of the power supply is consistent with the voltage on the device
nameplate.
Make sure the scissors work properly to ensure that the electric scissors work in an
optimal state.
When the device is turned off, the blade will continue to run for some time. Wait for the
blade to stop. Do not touch or block moving blades. Otherwise, it will cause danger!
1) Turn on the power switch, and after hearing the prompt tone, pull the switch twice
continuously within 1 second. After hearing the prompt tone again, the pruning shear is
in a working state, and the trigger can be started.
2) If the pruners stop working during long term use and you hear 4 fast beeps, this is an
indication of undervoltage protection which means the battery is depleted. Please charge
as soon as possible.
3) In order to conserve the use of battery power and ensure that the pruning shears have
the longest service life, do not overload the device and prohibit it from being used for
cutting more than 35mm wet branches and .30 dry branches.
4) During the shearing process, if the shearing knife encounters a branch that cannot be
cut off, then release the trigger to be reset to the opening position, after which the next
normal shear session can be carried out.