![background image](http://html1.mh-extra.com/html/zenoah/lrt2300/lrt2300_owners-manual_3474969005.webp)
GB-5
LRT2300
G
B
neither the cutting attachment
nor the throttle trigger come into
contact with any obstacle when
the engine starts.
WARNING
Never place the throttle trigger
into the high-speed position
when starting the engine.
3. After starting the engine, check
to make sure that the cutting at-
tachment stops rotating when the
throttle is moved fully back to its
original position. If it continues to
rotate even after the throttle trig-
ger has been moved fully back,
turn off the engine and take the
unit to your authorized ZENOAH
servicing dealer for repair.
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by
the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand.
Place your feet slightly apart
(slightly further apart than the
width of your shoulders) so that
your weight is distributed evenly
across both legs, and always be
sure to maintain a steady, even
posture while working.
2. Maintain the speed of the engine
at the level required to perform
cutting work, and never raise the
speed of the engine above the
level necessary.
3. If the unit starts to shake or vi-
brate, turn off the engine and
check the whole unit. Do not use
it until the trouble has been prop-
erly corrected.
4. Keep all parts of your body away
from moving cutting attachment
and hot surfaces.
5. Never touch the muffler, spark
plug, or other metallic parts of
the engine while the engine is in
operation or immediately after
shutting down the engine. Doing
so could result in serious burns
or electrical shock.
BEFORE STARTING
THE ENGINE
1. The area within a perimeter of
15 m (50 ft) of the person using
the product should be consid-
ered a hazardous area into which
no one should enter. If neces-
sary, yellow warning rope, warn-
ing signs should be placed
around the perimeter of the area.
When work is to be performed
simultaneously by two or more
persons, care should also be
taken to constantly look around
or otherwise check for the pres-
ence and locations of other
people working so as to maintain
a distance between each person
sufficient to ensure safety.
2. Check the condition of working
area to avoid any accident by
hitting hidden obstacles such as
stumps, stones, cans, or broken
glass.
IMPORTANT
Remove any obstacle before begin-
ning work.
3. Inspect the entire unit for loose
fasteners and fuel leakage. Make
sure that the cutting attachment
is properly installed and se-
curely fastened.
4. Always use the harness. Adjust
the harness for comfort before
starting the engine. The harness
should be adjusted so the left
hand can comfortably hold the
handlebar grip approximately
waist high.
STARTING THE ENGINE
1. Keep bystanders and animals at
least 15 m (50 ft) away from the
operating point. If you are ap-
proached, immediately stop the
engine.
2. The product is equipped with a
centrifugal clutch mechanism, so
the cutting attachment begins to
rotate as soon as the engine is
started by putting the throttle
trigger into the start position.
When starting the engine, place
the product onto the ground in a
flat clear area and hold it firmly
in place so as to ensure that
5. For safe operation