Zenoah EBZ8550, Руководство оператора, Страница: 11 / 44

7. Pull the starter rope handle slowly until resistance
occurs.
8. Pull the starter rope handle quickly with your right
hand until the engine starts or tries to start,
maximum 10 times. If the engine starts, move the
choke lever gradually to the open position.
CAUTION: Do not pull the starter rope
handle to full extension and do not let go
of the starter rope handle.
9. Move the choke lever to the open choke position
until the choke lever stops.
10. Pull the starter rope handle until the engine starts
and stays on.
11. If the engine does not start, do step 1 to step 10
again.
12. Let the engine operate for 2-3 minutes to become
warm before operation of the product.
To stop the product
CAUTION: Do not stop the product at full
speed.
1. Push the throttle lever to the stop position.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
Maintenance Daily Weekly Monthly
Clean the external surface. X
Make sure that the throttle control operates correctly. X
Make sure that the stop switch operates correctly. X
Do a check of the stop switch, refer to To stop the product on page 11. X
Examine the engine, the fuel tank and the fuel lines for leaks. X
Clean the air filter. Replace if it is necessary. X
Tighten nuts and screws. X
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace if it is necessary.
X
Examine the air intake and make sure that it is not blocked. X
Examine the starter and the starter rope for damages. X
Examine the vibration damping units for damages and cracks. X
Examine the spark plug, refer to
To do a check of the spark plug on page 12.
X
Clean the cooling system. X
Clean the external surface of the carburetor and the area around it. X
Clean the fuel tank. X
1321 - 001 - 09.09.2019 11