GB-16
BCZ4505DW / BCZ4505CL / BCZ5010DL / BCZ5010DW / BCZ5010CL
9. Maintenance
REFILLING TRIMMING LINE
(BCZ4505CL / BCZ5010CL)
WARNING
• For safety reasons, do not use metalreinforced line.
1. Press the latches oppositely on the housing side wall.
Then put off the cover. (*1)
2. Take off the spool from the cover. Clean up the spool
grooves. (*2)
3. A nylon line is cut in 10m. Then that line is cut more in
half. (*3)
4. One nylon line is inserted in the hole at the surface of
the spool. (*4)
5. Other nylon line is inserted in the hole at the bottom
of the spool. (*5)
6. Each line is bent in each groove of the spool.
7. Wind two nylon lines around each groove of the spool
tightly to the direction of the arrow on the spool flanges.
(*6)
8. Hold the lines to the line holding notches on one of
spool outer flanges. Leave 4 inches of the line from
the notches. Do not lot the lines loosen. (*7)
9. Put the spool onto the cover at the position meet the
holding notches with the eyelets on the cover. (*8)
10. Set the lines into the eyelets through the slit on upper
side of the eyelets. (*9)
11. Set the spool into the housing, meet the eyelets to
the eyelet slots of the hosing. (*10)
IMPORTANT
Make sure that the latches fully spread in the win-
dows of the cover.
Cover window
Housing latch
Spool
Cover
Latch
Press
Put off
Nylon line
The surface of spool
One end of
nylon line
Hole
The bottom of spool
One end of the
other nylone line
Hole
Wind lines around each groove
Follow a note
One of the lines
each can be wound, too
Line holding notch
Leave 4 inches
Line
holding
notch
Eyelet
Eyelet
Eyelet
slot
Eyelet
