BC2604DL / BC2604DW
GB-8
INSTALLING DEBRIS GUARD FOR LINE HEAD
• Attach the debris guard (RED) with the bolts provided.
INSTALLING LINE HEAD
1. While locking the gear shaft by inserting the supplied tool
into the upper holder on the gear box, loosen and remove
the bolt (left-handed).
2. Fit the line head assembly to the gear shaft by using bolt
(A). Hand tighten it securely.
INSTALLING DEBRIS GUARD FOR METAL BLADE
• Attach the debris guard (BLACK) with the bolts pro-
vided.
BLADE
1. Put the angled bar into the side holes of the inner holder and
the gearcase.
2. Remove the blade bolt (Lefthanded) and the outer holder
from the gearshaft.
3. Put the blade onto the inner holder. Make the marked side
face the holder.
4. Put the outer holder onto the gearshaft making the recessed
side face the blade.
5. Fasten the blade by the blade bolt with the spring washer
and the bolt cover .
BALANCE UNIT
1. Put on strap and attach unit to strap.
2. Slide clampi up or down until unit balances with head
aparting from the ground when using it.
INSTALLING HANDLE (BC2604DL)
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you.
INSTALLING HANDLE (BC2604DW)
1. Loosen the 4bolts on the upper cap and insert the
handles equally. Retighten the bolts.
2. Put the handle assembly into the bracket and put the
upper cap over it. Tighten the cap securely.
CONNECTING THROTTLE WIRE (BC2604DW)
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
NOTE
• When installing the cleaner cover, make sure to put
the high-tension wire in it.
CONNECTING SWITCH WIRES (BC2604DW)
• Connect the switch wires between the engine and the
main unit. Pair the wires of the same color.
PROTECTOR (BC2604DW)
• Wrap the protector around the outer pipe as shown in
the figure, and fasten the hooks.
6. Set up
