Securel v3
Technical Support:
6
1.3
INSTALLATION
Securel v3 connects to the KNX bus through the on-board KNX connector. Once the
device is provided with power from the KNX bus, both the individual address and the
associated application programme may be downloaded.
Figure 1.
Securel v3.
Elements.
The elements are described next:
Pairing button (1):
provided that the serial channel is enabled,
a long press
(longer than three seconds) will activate the pairing mode.
Auxiliary power supply (3):
slots for the connection of
external
24VDC
power supply
.
Electric strike output (4):
output ports for the insertion of the electric strike.
Encrypted communication (5):
transmit (Tx) and receive (Rx) terminals
through which the encrypted communication between Securel v3 and access
control module is established.
Figure 2 shows an example of a connection diagram of IWAC Display v3,
Securel v3, power supply and electric strike:
1.
Pairing Button.
2.
Pairing LED.
3.
Auxiliary Power Supply.
4.
Electric Strike Output.
5.
Encrypted Communication.
6.
Output Status LED.
7.
Manual Control Button.
8.
Prog./Test Button.
9.
Prog./Test LED.
10.
KNX Connector.
11.
Fixing clamp.
