ZENN
iO
AVANCE Y TECNOLOGÍA
vwww.zennio.com
38
38
Temperature sending period:
this is intended to set the period (in tens of a second) for
a cyclical sending to the KNX bus of the current temperature value. Setting this to 0 indicates
that no periodical sending will take place.
Send with a temperature change:
the current value of the temperature will be sent to
the KNX bus when it shows an increment or decrement (compared to the previous measure)
greater than the amount set by parameter (from 0 to 200 tenths of a degree).
Temperature protection:
permits enabling overheating, overcooling or both protections.
Depending on the chosen protection, one or two communication objects will be enabled: "[Ix]
Overheating" and "[Ix] Overcooling", which will indicate (with the value "1") if the
corresponding limit has been exceeded. It is necessary to define the overheating or the
overcooling temperature (or both), in degrees, as well as a hysteresis value (tenths of a
degree).
3.4.3. MOVEMENT DETECTOR
When an input is configured as a Movement detector, up to two detection channels can be
enabled (per input).
Figure 3.16. Input: Movement detector
After enabling the available channels, the following configuration window will be shown:
