Zennio Linecoupler
Technical Support:
http://zennioenglish.zendesk.com
7
2
CONFIGURATION
2.1
GENERAL CONFIGURATION
Zennio Linecoupler can be used as a
line coupler
(for coupling both a sub-line
to a
mainline,
or a mainline to a
backbone line
; the latter is normally referred to as
“
backbone coupler
”) or as a
repeater
(for coupling two sub-line segments). A different
application program is provided for each purpose.
2.1.1
ZENNIO LINECOUPLER AS A LINE COUPLER
Figure 2 shows a typical scenario where Linecoupler can be installed. As a line
coupler, the device may perform line coupling in the nodes marked as “LC”, where a
sub-line connects to a mainline or a mainline connects to a backbone line. In both
cases, Linecoupler offers an insulated coupling interface with the possibility of filtering
the traffic according to the topology in the installation or to group-oriented criteria. In
other words, Linecoupler will (or will not) let telegrams pass from one line to the other
according to the parameterisation.
Another scenario is shown in Figure 4.
Figure 4
Line Coupling Scenario
3.0.0
4.0.0
3.1.0
4.1.0
4.2.0
3.2.0
4.2.1
3.2.1
4.1.1
4.1.2
3.1.1
3.1.2
4.0.1
3.0.1
