© Zennio Avance y Tecnología S.L.
Edition 3
Futher information
Page 2/2
SAFETY INSTRUCTIONS
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each cou ntry.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for th e entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini -circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
Keep the device away from water and do not cover it with clothes, paper or any other material while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions at
http://zennio.com/weee-regulation.
OUTPUTS SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Number of outputs
4
Output type
Solid state switching device
Maximum
recommended load per
output (AC/DC)
Quantity of valves ²
5
Stationary current
200mA (@ 35°C)
Maximum inrush current
2.5A
Short-circuit protection
YES
Overload protection
YES
Connection method
Screw terminal block
Cable cross-section
0.5-4mm² (IEC) / 26-12AWG (UL)
² This value could be more restrictive depending on the valve stationary current and inrush current.
EXTERNAL POWER SUPPLY SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Voltage
230VAC 50/60Hz
Connection method
Screw terminal block
Cable cross-section
0.5-4mm² (IEC) / 26-12AWG (UL)
Connecting more than one valve to each output is allowed as long as the maximum current per output is not exceeded:
WIRING DIAGRAMS
230VAC
50/60Hz
Valve 1
Valve
n
(n≤5)
Valve
Figure 2: Wiring example: several valves per output and one valve per
output.
Figure 3: Mounting HeatingBOX 230V 4X on
DIN rail
Attaching HeatingBOX 230V 4X to DIN rail:
Removing HeatingBOX 230V 4X from DIN rail:
•
NOTE
: Simultaneous connection of one
valve to several outputs is not allowed.
Several valves per output
connection schematic
One valve per output
connection schematic
