BIN 44 / 4X / 2X
http://www.zennio.com
Technical Support:
http://support.zennio.com
8
2
CONFIGURATION
2.1
GENERAL
After importing the corresponding database in ETS and adding the device into the
topology of the desired project, the configuration process begins by entering the
Parameters tab of the device.
ETS PARAMETERISATION
The only parameterisable screen available by default is General. From this screen it is
possible to activate/deactivate all the required functionality.
Figure 3.
Default configuration (BIN 44).
Start-up Delay
[
0
…255
]
1
: sets a delay after the initialisation so the device does
not respond to orders nor send objects to the bus (except the Heartbeat object,
if enabled; see below).
Input / Output x
[
Disabled
/Binary Input/LED Lighting Output/Electronic Relay
Control (Heating Actuator)
]
:
checkboxes that allow selecting which inputs and
1
The default values of each parameter will be highlighted in blue in this document, as follows:
[
default
/rest of options
].