34/EN
Adjusting the amount of rinse
aid
1. After turning on your machine, press
and hold the Time Delay and Start /
Pause / Cancel keys respectively.
2. Using the Time Delay key, turn on the 6
LED.
3. You can use the function keys to adjust
the rinse aid level.
If the 1st programme indicator is on, no
rinse aid will be dispensed
If the 2nd programme indicator is on, 1
dose of rinse aid will be dispensed.
If the 3rd programme indicator is on, 2
doses of rinse aid will be dispensed.
If the 4th programme indicator is on, 3
doses of rinse aid will be dispensed.
If the 1st, 2nd, 3rd and 4th programme
indicators are on, 4 doses of rinse aid will
be dispensed.
4. Press the On/Off key to exit the
settings menu. Your setting will be
saved automatically.
Rinse Aid Indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
End of programme
When the programme you have
selected comes to an end, an audible
warning signal will warn you to turn off
your machine. This audible signal will
warn you with certain intervals before it
turns off.
Start / Pause indicator will go off once the
washing programme has ended.
1. Open the door of the machine.
2. Press the On/Off key to switch off your
machine.
3. Close the tap.
4. Unplug the machine from the socket.
For energy saving, the machine is
automatically switched off following the
completion of the programme or when
the programme is not started.
Leave your dishes in the machine
for about 15 minutes after they are
washed in order to have them cooled.
Your dishes will dry in a shorter time
if you leave the door of your machine
ajar during this period. This process
will increase the drying effectiveness of
your machine.
Water Cut-off Warning
If mains water is cut off or water inlet tap
is turned off, the machine will not take
water in and water off indicator will flash.
As long as the problem continues, washing
programme is paused and the water inlet
is checked regularly by the machine; when
the water is restored water off indicator will
disappear after a while and the washing
programme resumes.
Overflowing Warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and
water overflow indicator will flash on the
Programme indicator. As long as the
overflowing continues the safety algorithm
will be active and try to discharge the water.
If overflowing stops and safety is assured,
water overflow indicator will disappear. If
the indicator does not disappear, there is a
permanent fault. In this case the authorised
service should be contacted.