B.25
Appendix
B
Command
Function
A
Immediately answer an incoming call.
N
Perform the last command issued again. For instance, can
be used to redial a number if the previous command was
dialed.
C
Argument (n) n
=
0 or 1 (default
=
1) CO turns the carrier
signal off; C1 turns the carrier signal on.
D
Argument (n ... n) n
=
0-9, * , #, P, R< T, ;, , Dials the
phone number expressed by the argument. The number
will be dialed with either tones or pulses depending on
how the last number was dialed. On power- up, this com
mand will default to pulse dialing.
DP
Argument (n ... n) n
=
0-9, * , #, P, R< T, ;, , Dials the
phone number using tone dialing. These are the special
characters that can be included in a dialing string:
E
p
R
T
Pulse dial the following numbers.
Enter answer mode after dialing number.
This character should only be at the end of
the dialing string.
Tone dial the following numbers.
Return to command state. You can now enter
other commands that are to be executed
while online.
Insert inside a dialing string for a two-second
pause during the dialing sequence. (Pause
duration can be changed by 58 register set
ting-- described later.)
Argument (n) n
=
0 or 1 (default
=
1) Determines if char
acters are echoed in the command state. EO is off; E1 is
on.
Содержание Z-170
