FIG. 1—CONTROLS
However, should the settings become mis-adjusted, it is a simple matter to adjust them as follows:
1. Turn the VHF channel selector knob to the channel number desired.
2. Turn VHF perma-set tuning knob until there is no picture.
3. Then turn perma-set tuning knob back slowly for best picture and sound.
4. Repeat for each channel to be set.
TONE CONTROL
Your Zenith is equipped with a tone control which enables you to personally select tonal values of unmatched richness
and fidelity. The high tonal register and the "bass" or low frequencies are emphasized by turning the tone control knob.
Set knob to the position most pleasing to your ear.
UHF TUNING
First, turn VHF CHANNEL SELECTOR to "UHF" Position. Turn UHF Channel Tuning Control for desired UHF
Channel. Then carefully turn UHF Fine Tuning knob for best picture and sound.
Disregard channel numbers 12 and 13 if they appear in the UHF indicator dial of your unit. These are VHF channels to
be tuned in with the VHF selector.
PEAK PICTURE (SOME MODELS)
Set this control for best picture crispness in your location. The strength of the signal being received and your personal
preference for picture detail will determine the optimum setting.
SERVICE
Your new Zenith television receiver is engineered for dependable long life service but like any mechanical or electrical
instrument, it will occasionally require maintenance. For service consult your Zenith dealer or refer to the organization
that installed your instrument. (See warranty.)
BRIGHTNESS
[3]
[4]
Page 4 of 8
Zenith Television Receiver Operating Manual, by Anonymous.
8/8/2009
http://www.yesterdayimage.com/27832-h/27832-h/27832-h.htm
