Zenith PRO1200X, Руководство по установке

Страница: 7 / 35

Safety instructions
1-2 206-3610 ZENITH PRO 1200X 151199
thinner or benzine, or abrasive cleaners, since these will damage
the cabinet.
To ensure the highest optical performance and resolution, the
projection lenses are specially treated with an anti-reflective coating,
therefore : avoid touching the lens. To remove dust on the lens, use
a soft dry cloth. Do not use a damp cloth, detergent solution, or thinner.
On AC Power
1. This product should be operated from an AC power source
only.
This product is designed to operate from either a nominal
system voltage of 120V or 240V.
However, this product has been shipped from the factory
equipped with a standard three conductor North American
power supply cordset for connection to a 15 A, 125 V, 60 Hz
branch circuit receptacle outlet.
If you are not sure of the type of AC power available, consult
your dealer or local power company.
If the power supply is not the correct one, consult your dealer.
2.THIS EQUIPMENT MUST BE GROUNDED (EARTHED) via the
supplied 3 conductor AC power cable. (If the supplied power
cable is not the correct one, consult your dealer.)
3. Do not allow anything to rest on the power cord. Do not locate
this product where people will walk on the cord. To disconnect
the cord, pull it out by the plug. Never pull the cord itself.
4. If an extension cord is used with this product, make sure that
the total of the ampere ratings on the products plugged into the
extension cord does not exceed the extension cord ampere
rating. Also make sure that the total of all products plugged into
the wall outlet does not exceed 15 amperes.
On installation
* Before operating your projector please read this manual thoroughly,
and retain it for future reference.
* Installation and preliminary adjustments should be performed by
qualified ZENITH personnel or authorized ZENITH service dealers.
* Do not place this projector on an unstable cart, stand, or table. The
projector may fall, causing serious damage to it.
* Do not use this projector near water.
* Use only the power cord supplied with your projector. While
appearing to be similar, other power cords have not been safety
tested at the factory and may not be used to power the projector.
For a replacement power cord, contact your dealer.
* Slots and openings in the cabinet and the sides are provided for
ventilation; to ensure reliable operation of the projector and to
protect it from overheating, these openings must not be blocked or
covered. The openings should never be blocked by placing the
product on a bed, sofa, rug, or other similar surface. This product
should never be placed near or over a radiator or heat register. This
projector should not be placed in a built-in installation or enclosure
unless proper ventilation is provided.
On Cleaning
Unplug this product from the wall outlet before cleaning. Do
not use liquid cleaners or aerosol cleaners. Use a damp cloth
for cleaning.
To keep the cabinet looking brand-new, periodically clean it with a soft
cloth. Stubborn stains may be removed with a cloth lightly dampened
with mild detergent solution. Never use strong solvents, such as