P A G E 1 8
206-3602
Hook Up Your Cable (CATV) to the TV
If you’re using a cable box, leave the TV on
channel 3 or 4 and use your cable box to
change channels.
If you’re using a cable box, Auto Program might
only find the channel your cable service is on
(usually channel 3 or 4). Don’t worry, that’s all
you need!
VIDEO
ANTENNA
CABLE
R- AUDIO- L
S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
COMPUTER
IN
AUDIO OUT
Cable TV
wall jack
Round wire (75 ohm)
Cable TV
wall jack
Cable box
In
Out
RF coaxial wire (75 ohm)
3 4
output
switch
VIDEO
ANTENNA
CABLE
R- AUDIO- L
S-VIDEO IN
COMPUTER
AUDIO
R
L
AUX IN
M.P.I.
TV back
R- AUDIO- L
R- AUDIO- L
S-VIDEO OUT
COMPUTER
IN
AUDIO OUT
Locate the Antenna/Cable jack on the back of
the Presentation TV.
Connect the cable that runs from the wall
directly to this jack, according to the diagram
to the right.
Remove the back of the remote and put in two
AAA batteries.
Plug in the TV. Do not plug it into a switched
outlet. Your Presentation TV is designed to
operate on standard current, 120-volt 60 Hertz
AC. Do not attempt to operate it on DC
Current.
Go to page 23 to Auto Program the
Presentation TV.
1
2
3
4
5
Connect cable service to the Presentation TV
back of
remote
