REFERENCE
15
Troubleshooting
Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power.
No sound.
The unit does not
start playback.
The remote control
does not work
properly.
Cause
• The power cord is disconnected.
• The audio cables are not
connected securely.
• The power of the external source
equipment is switched off.
• The Digital Audio Output is set
to the wrong position.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the
guide.
• The disc is dirty.
• The remote control is not pointed
at the remote sensor of the unit.
• The remote control is too far
from the unit.
• There is an obstacle in the path
of the remote control and the
unit.
• The batteries in the remote
control are exhausted.
Correction
• Plug the power cord into the wall
outlet securely.
• Connect the audio cable into the
jacks securely.
• Switch on the external source
equipment.
• Set the Digital Audio Output to
the correct position, then turn on
the unit again by pressing
POWER.
• Insert a playablw disc.
• Place the disc with the playback
side down.
• Place the disc on the disc tray
correctly inside the guide.
• Clean the disc.
• Point the remote control at the
remote sensor of the unit.
• Operate the remote control
within about 23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new
ones.
