Locate the Antenna/Cable In jack on the back
of the VCR.
Connect the wire that runs from the antenna,
according to one of the diagrams to the right. As
required, make the other connections as shown to
the right.
Remove the back of the remote, put in
two AA batteries.
Plug in the TV. The TV is designed to operate on
standard current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC power.
Go to page 12 to Auto Program the TV.
206-3854
P A G E 8
Hook Up Antenna and VCR to the TV
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
Flat Wire
(300 ohm)
Antenna
300/75 ohm
Adapter
A/V cables
not included
with TV
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
A/V cables
not included
with TV
RF Coaxial Wire
(75 ohm)
Antenna
Back of
Remote
120 V AC
60 Hz
1
2
3
4
5
Connect an off-air antenna and VCR to the TV
No A/V cables are included with the Zenith TV.
Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
