9.
Mount the unit to the wall.
WARNING: FOR SAFETY REASONS, IT IS
IMPERATIVE THAT THIS UNIT BE
MOUNTED TO THE WALL. WE HAVE
PROVIDED MOUNTING HARDWARE FOR
YOUR CONVENIENCE.
Mounting Instructions:
Warning
: Before cutting, drilling or ham-
mering into any wall surface, verify the
location of electrical, plumbing and gas
lines. Cutting any of these may cause
serious injury.
1.
Mark mounting points on wall through
holes in the back tubes of the unit.
2.
Hammer wall anchors (J) into wall, unless
mounting screws (H) will go directly into a
stud.
(
NOTE:
Do not use a wall anchor if
mounting screw will be going into a stud.)
Wall anchors (J) should be oriented with the
flat side horizontal.
3.
Place unit against wall, lining up wall
anchors (J) and holes in rear tubes.
4.
Complete mounting by tightening mount-
ing screws (H) through mounting spacers (I)
into studs or wall anchors (J).
Pg 9 of 10
H
I
J
Wall anchors (J) should be oriented with the flat side horizontal.
IS9012-I7
