Zenith 56DC1DUC, Инструкция по установке и эксплуатации, Гарантия, Страница: 13 / 47

Owner’s Manual 13
Installation
• Component Input ports
To get better picture quality, connect a DVD player to the
component input ports as shown below.
Component ports
on the TV
Y P
B
P
R
Video output ports
on DVD player
Y
Y
Y
Y Pb
B-Y
Cb
P
B
Pr
R-Y
Cr
P
R
How to connect
1. Connect the DVD video outputs (Y, P
B
, P
R
) to the COMPO-
NENT (Y, P
B
, P
R
) INPUT jacks on the TV and connect the
DVD audio outputs to the AUDIO INPUT jacks on the TV, as
shown in the figure.
2. If your DVD only has an S-Video output jack, connect this to
the S-VIDEO input on the TV and connect the DVD audio out-
puts to the AUDIO INPUT jacks on the TV, as shown in the fig-
ure.
Note: If your DVD player does not have component video output,
use S-Video.
How to use
1. Turn on the DVD player, insert a DVD.
2. Use the
TV/VIDEO button on the Remote Control to select
Component 1 or Component 2 . (If connected to S-VIDEO,
select the Video2 or Front Video external input source.)
3. Refer to the DVD player's manual for operating instructions.
DVD Setup
DVD Setup
S-VIDEO
P
R
P
B
Y
MONO
RGB INPUT
COMPONENT
INPUT2 INPUT1
DTV/DVD INPUT
RGB/DVI INPUT
(L)
(R)
AUDIO
(L)
(R)
AUDIO
VIDEO
(L)
(R)
AUDIO
(L)
(R)
AUDIO
MONITOR
OUT
INPUT2 INPUT1
DIGITAL AUDIO
OPTICAL INPUT
(COMPONENT2)
DIGITAL AUDIO
OPTICAL INPUT
(DVI)
DIGITAL AUDIO
OPTICAL OUTPUT
ANTENNA
H
D
M
I
1
VARIABLE
AUDIO OUT
UPGRADE
PORT
CABLE
/
D
V
I
H
D
M
I
2
(R) AUDIO (L) S-VIDEO
B R
(R) AUDIO (L) DIGITAL AUDIO
OPTICAL
PC/DTV
(XGA/
480p/
720p/
1080i)
DVD
Notes:
• Digital Audio will not work for Component 1 input source.
• Digital Audio operation has priority if Digital Audio and AUDIO L/R
are connected at the same time.
or
How to connect
Use the TV’s COMPONENT (Y, P
B
, P
R
) INPUT, RGB, HDMI1/DVI or
HDMI2 jack for video connections, depending on your set-top box connec-
tor. Then, make the corresponding audio connections.
Note : HDMI(High Definition Multimedia Interface): Input that accepts uncom-
pressed digital signal and multi channel digital audio signal.
How to use
1. Turn on the digital set-top box. (Refer to the owner’s manual for the digital
set-top box.)
2. Use TV/VIDEO on the Remote Control to select Component 1 ,
Component 2 , RGB-DTV , HDMI1/DVI or HDMI2 source.
HDSTB Setup
HDSTB Setup
- This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital
signals from a digital set-top box or other digital external device, refer to the figure as shown below.
- This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).
Signal
480i
480p
720p
1080i Component 1/2
Yes
Yes
Yes
Yes
RGB-DTV,HDMI1/DVI,HDMI2
No
Yes
Yes
Yes