RCS01 - Product Manual
2 Operation
Desktop Charging Station shown with 3 empty bays.
!
!
•
INSERT THE TRANSMITTER FACING FORWARDS.
•
DO NOT FORCE THE TRANSMITTER DOWN.
POWER
SWITCH
POWER SUPPLY
IEC INLET
L
The LED on the RPA Transmitter
indicates the charging progress:
AMBER: Battery is charging.
GREEN: Battery is charged.
POWER ON LED
LID
Do not place anything in the Charging Station other than the RPA01 transmitter. You might
damage the contacts, this may prevent the RPA01 transmitter from charging.
!
!
Charging a Battery
1.
Switch the power supply ON, using the power switch.
The
power
LED illuminates to indicate that the Charging Station is powered on.
2.
Lift up one of the charging bay lids, and place the RPA01 transmitter into one of the four bays so that the
battery contacts meet the charger contacts.
The transmitter should be only inserted with the display and buttons facing towards as
shown in the above figure, and must not be forced.
!
!
3.
The LED on the RPA01 transmitter will illuminate AMBER to indicate that charging is in progress.
Charging will usually be completed within two hours.
4.
When charging is complete, the LED on the RPA Transmitter will change to GREEN.
5.
Lift the RPA01 transmitter out of the charging bay.
The protective lid will then drop back down over the charging bay.
Issue: 03 complete, approved
Page 6 of 24